Hi all,
I've updated firmware to 1.3.0 build 250407. Coincidentally I have also had building work take place where landing PIR and front door contact were briefly removed and refitted.
I have two zones setup for day alarm and night alarm. Night alarm omits the landing PIR.
When the alarm is set and is disarmed I get perimeter breach for the zones. No alarm bell / siren has been triggered and there is a constant warning light on the front panel. The front panel being connected via ethernet.
In the hikconnect app and also Web browser all devices report as normal and no faults are present.
If I set the alarm and quickly disarm, I don't get this behaviour. It's only after being armed for perhaps 10 mins and longer.
Any ideas as I'm all out of them.
Thank you!
I've updated firmware to 1.3.0 build 250407. Coincidentally I have also had building work take place where landing PIR and front door contact were briefly removed and refitted.
I have two zones setup for day alarm and night alarm. Night alarm omits the landing PIR.
When the alarm is set and is disarmed I get perimeter breach for the zones. No alarm bell / siren has been triggered and there is a constant warning light on the front panel. The front panel being connected via ethernet.
In the hikconnect app and also Web browser all devices report as normal and no faults are present.
If I set the alarm and quickly disarm, I don't get this behaviour. It's only after being armed for perhaps 10 mins and longer.
Any ideas as I'm all out of them.
Thank you!
