Enable Virtual Host in NVR 5

[Mattycee2K17]

I have had a search and keep coming up short and cannot find the settings I need to enable Virtual Host in the settings on the newest NVR 5.0 software.
Is someone able to advise were I can turn that switch on?
Thanks

 

[sportster]

via the WEB UI interface on v5.03.010.... navigate here:

Device Access --> Device --> Video Device --> ...more --> Virtual Host Configuration

 

[Mattycee2K17]

Thanks very much, you're a legend.

 

[Kyle]

Also, you don't actually need to use virtual host any more on the 5.0 firmware - on the Video Device page, you should have an 'Operation' column at the end which has a button allowing you to log in to each camera

How-to: - How to connect an IP camera to a Hikvision NVR

Adding cameras to your Network Video Recorder (NVR) is a crucial step in any CCTV setup. Not only does it allow you to store and access all your camera recordings in one place, but it also simplifies camera configuration. In this simple step-by-step guide, we’ll show you how to add cameras to a...

www.use-ip.co.uk

The advanced image settings, which you used to only be able to access via virtual host, are also now available in the NVR's image settings.