cb918
New Member
- Messages
- 2
- Points
- 1
Good Evening Folks,
I installed my new setup yesterday morning and feel like it went well overall but I've had absolutely no luck with motion detection at all. I feel like I've exhaused all options and would welcome some thoughts on what I may have missed.
I'm using analogue HiLook Turbo cameras with a HiLook branded DVR. I done all the setup remotely via web interface, the camera quality is good, it's recording 24/7 and I have both live view and playback working well on our mobile devices using the HiLook app - downloaded from the Hikvision App Store rather than Google Play Store. I set up the mobile devices using IP.
My intention is to have the DVR record each camera continuously but notify us when there is motion detected in certain zones. My attempt was to get a notification when any motion was detected - I went to Event > Basic Event > Motion and for each camera I enabled motion detection, the arming schedule untouched (All purple/on?) and on the Linkage section selected Notify Surveillance Center. Once saved I thought that was it, but nothing ever shows on either the web interface or mobile app when the cameras have motion.
Is there something I have missed? I've provided more information on the actual DVR and firmware below and some screenshots here.
DVR: DVR-204U-K1
Firmware: V4.30.120 build 200630
Many thanks in advance for any suggestions.
Kind Regards,
Chris.
I installed my new setup yesterday morning and feel like it went well overall but I've had absolutely no luck with motion detection at all. I feel like I've exhaused all options and would welcome some thoughts on what I may have missed.
I'm using analogue HiLook Turbo cameras with a HiLook branded DVR. I done all the setup remotely via web interface, the camera quality is good, it's recording 24/7 and I have both live view and playback working well on our mobile devices using the HiLook app - downloaded from the Hikvision App Store rather than Google Play Store. I set up the mobile devices using IP.
My intention is to have the DVR record each camera continuously but notify us when there is motion detected in certain zones. My attempt was to get a notification when any motion was detected - I went to Event > Basic Event > Motion and for each camera I enabled motion detection, the arming schedule untouched (All purple/on?) and on the Linkage section selected Notify Surveillance Center. Once saved I thought that was it, but nothing ever shows on either the web interface or mobile app when the cameras have motion.
Is there something I have missed? I've provided more information on the actual DVR and firmware below and some screenshots here.
DVR: DVR-204U-K1
Firmware: V4.30.120 build 200630
Many thanks in advance for any suggestions.
Kind Regards,
Chris.